Restaurant Equipment Maintenance Checklist for Florida Heat
Daily, weekly, monthly and quarterly maintenance for walk-ins, reach-ins, ice machines, fryers, ovens, dish machines and hood fans in a South Florida kitchen, split into what staff can do and what a technician should handle.
A Miami kitchen runs its equipment through a summer that lasts from May into October, with outdoor air in the 90s, dew points in the mid-70s and salt in the air near the coast. Many of the breakdowns we see in July started in April as a dirty condenser coil or a torn gasket. This checklist is the one we would leave with a kitchen manager. Most of it takes your staff a few minutes. The quarterly work belongs to a technician.
Every day
Read the thermometer in every walk-in and reach-in at opening and again at closing, and write both numbers down. Cold-held food has to stay at 41°F or below. Check that each door swings shut and latches on its own, and that nobody has stacked boxes against a condenser.
Fryers: filter the oil on the schedule in the fryer's manual, which in a busy kitchen is usually at least once a day, and keep the oil at the fill line. A fryer running low on oil overheats faster.
At the start of service, look at the dish machine's wash and rinse gauges; a high-temp machine needs a 180°F final rinse. At close, drain it, rinse the scrap screens and curtains, and leave the door open to dry.
Glance at the ice. Cloudy, thin or hollow cubes are often the first sign of scale or a water problem. Scrape the griddles and charbroilers and empty the grease trays before the closing crew leaves.
Every week
Wipe the door gaskets on every cooler with warm soapy water and look for tears, starting at the corners. Then close each door on a dollar bill at a few points around the frame. Where the bill slides out with no drag, the gasket isn't sealing. Our guide to a walk-in door that won't close or seal covers the hinges and closers too.
Run the hood's baffle filters through the dish machine or soak them. That part is your staff's job; cleaning the ducts belongs to a certified hood cleaning company.
Delime the dish machine on the schedule your chemical supplier sets. With South Florida's hard water that is often weekly. While you're down there, check under each reach-in for water, since a puddle usually means a clogged condensate drain.
Every month
Clean the condenser coils on reach-ins and prep tables with the power off, using a coil brush or a vacuum. How often depends on where the unit sits. Our True T-Series cleaning schedule puts a reach-in near the cook line within two miles of the ocean at about every 8 weeks, and an inland unit away from the fryers at 14 to 18 weeks. In a coastal kitchen, monthly is a safe habit.
Check every cooler thermometer against a probe thermometer, and do the same with the fryer dial. If a fryer set to 350°F reads 365°F on the probe, book a thermostat calibration before the drift gets worse.
Clean and sanitize the ice bin and look at the date on the water filter. On ovens, check the door gaskets and run an oven thermometer at a set temperature to see whether it holds.
Every three months: the technician visit
Most kitchens on our maintenance plans get a visit every quarter. That visit covers the work that needs meters or refrigerant certification.
On walk-ins the tech cleans the condenser coil and checks the fan motors, defrost heaters and timer, the drain line, the door gaskets and heater wire, and the temperature log. Rooftop units near the coast sometimes need visits more often.
Ice machines get descaled and sanitized, with a new filter, a cleaned bin and dispenser, and a check of the probes and floats. Manufacturers call for this at least every six months, and a busy bar or a hot back room often needs it every three to four.
On fryers the work is thermostat calibration, a high-limit test, the pilot and thermocouple, the gas connections and the filter pump. Ovens and combis get their igniters, blower motors, door seals and temperature calibration checked, plus a steam generator descale on combis. Dish machines get wash and rinse temperatures, a booster descale, the wash arms and the chemical feed. Hood fans get belts, bearings and motors.
After each visit you should get a short report of what was cleaned or adjusted and the readings taken, plus a price for any part worn enough to replace soon. That is how our preventive maintenance plans work, priced per kitchen after a walkthrough.
Before summer, in April or May
Heat is what turns a small problem into a breakdown here. Before June, have the condenser coils cleaned on every walk-in and reach-in, rooftop units included. Look at the condenser fan motors and blades for rust; near the beach, salt gets to them first.
Check the walk-in door closers and the heater wire in the frame. In humid air a door that leaks lets in moisture that ices the evaporator coil. Ice machines lose production in summer heat, so an extra descale and a condenser cleaning in May help them keep up in August.
June 1 is also the start of hurricane season. The hurricane season prep guide covers power loss and restarting equipment after an outage.
Before the season, in September
Many Miami kitchens take in most of their year's revenue between October and May, so September is the month to fix whatever limped through the summer. Our pre-season equipment audit goes through it one asset at a time.
Keep a log
A notebook taped inside the office door is enough. Write the date, the unit, the reading and what was done. When a technician arrives, the log answers in a minute what would otherwise take twenty to find out, and it gives an inspector the paper trail they ask for.
Sometimes the checklist turns up something your staff can't fix: a box that won't come down to 41°F, a rinse stuck below 180°F, a pilot that keeps going out. Book a visit through our restaurant equipment repair page or call (754) 345-4515. Refrigeration problems can go straight to walk-in cooler repair or commercial ice machine repair.
$89 commercial service call, free with the approved repair. Same-day dispatch across South Florida.
More field guides
Pre-Tourist-Season Equipment Audit: Miami's October-to-May Peak
Miami's commercial kitchens push 60 to 70 percent of annual revenue between October and May. September is the audit window. Here's the asset-by-asset pre-season check that prevents the avoidable mid-season failure.
True T-Series Condenser Cleaning Schedule: Coastal vs Inland South Florida
A True T-49 in a Brickell rooftop kitchen needs the condenser cleaned every 8 weeks. The same unit in Doral 9 miles inland goes 16 weeks between cleanings. Here's the salt-air, hood-grease, and ambient-temp math behind why.
Hurricane Season Prep for Restaurant Kitchens: Power, Food, Equipment
October is peak Atlantic hurricane month. A 48-hour power outage destroys $8k in walk-in product, kills marginal compressors on restart, and creates insurance-claim documentation work most operators aren't prepared for.