Skip to main content
BerneCommercial
24/7 commercial dispatchSame-day serviceLicensed & InsuredParts warranty up to 10 years
Blog/Restaurant Operations

Emergency Restaurant Equipment Repair: What to Do in the First Hour

The walk-in is warming up, the fryer won't light or the dish machine can't reach 180°F in the middle of service. What to check first, how to protect the food and the inspection, and when to call an emergency technician in South Florida.

·7 min read
Commercial service call: $89Same-day dispatch

Kitchen equipment rarely quits at ten on a Tuesday morning. It goes during the Friday push or an hour before Sunday brunch, when the walk-in is full and nobody has a minute to think. What the manager does in the first hour decides how much product ends up in the dumpster, and sometimes whether a $200 repair turns into a lost night. This is the order we would work in, from safety to the food to the phone call.

First, rule out a safety problem

If you smell gas, close the gas valve on the appliance or the kitchen's main shutoff and open the back door. Don't flip switches or unplug anything near the smell. If it doesn't fade within a few minutes, get everyone out and call the gas company's emergency line or 911 from outside. A yellow, sooty flame on a range or an oven belongs in the same group: turn it off and call.

With electrical trouble, like a burning smell, a breaker that trips again the moment you reset it or water pooling around a unit's cord, switch the breaker off and leave it off until a technician has looked. And never reset a fryer's high-limit and keep cooking. The high-limit is the backup that trips after the thermostat has already failed, and cooking past it is how fryer fires start.

Walk-in or reach-in losing temperature

Write down the temperature and the time. Then check the cheap causes before you call. Is the door closing and latching, with the strip curtain down? Is the evaporator coil inside a block of ice? Is the condenser fan outside or on the roof spinning? Has a breaker tripped?

A defrost cycle can fool you. It runs 15 to 45 minutes, the box can rise 2 to 6°F while it runs, and it should recover within about half an hour after. A box that keeps climbing past that isn't in defrost. Our guide to walk-in temperature drift goes through the call-or-wait decision step by step.

Meanwhile, protect the food. Under the FDA Food Code that Florida inspectors enforce, cold-held food has to stay at 41°F or below. Move raw proteins, dairy and cut produce to a cooler that works or onto ice, keep the door shut, and log the temperature every 30 minutes. That log tells you what to keep and shows an inspector what happened. Product that sat above 41°F for an unknown stretch goes in the trash.

Call right away if the box is above 41°F and still rising with the door shut, if the compressor is silent, if you hear hissing or if the coil is iced solid.

Fryer won't light or won't hold temperature

Start with the gas. Fryers on casters connect through a quick-disconnect hose, and a hose that was pulled for cleaning and pushed back only part of the way starves the burner. Check that the valve is open, then relight the pilot following the steps on the label inside the door.

If the pilot goes out the moment you let go of the knob, the thermocouple or thermopile is the usual cause. That repair runs $80 to $160, and the part is on our trucks. A fryer that drops to standby mid-rush often has a failed temperature probe. Oil that smokes or runs past the set point means the thermostat has failed: turn that fryer off and move the menu to the ones still working.

Frymaster fryers with built-in filtration can lock out the filter pump; our Frymaster filter pump lockout guide walks through the reset.

Dish machine stuck below 180°F

A high-temp machine sanitizes with heat. With a final rinse below 180°F, plates come out looking clean but they aren't sanitized. Until the booster is fixed, switch to the three-compartment sink: wash, rinse, then sanitize with chemical sanitizer at the strength your test strips confirm.

Check the simple things first: the breaker for the booster heater, the water heater that feeds the machine, and whether someone switched the booster off at night. If the temperature still won't come up, the booster element is usually scaled or burned out, and that repair runs $180 to $620. Our guide to rinse temperature and sanitizer balance explains what an inspector checks.

Ice machine stopped making ice

The Food Code treats ice as food, so don't keep scooping from a bin that smells or has slime on the walls. Buy bagged ice for the night. Then check the water supply valve behind the machine and when the filter was last changed. A machine that runs but never drops a harvest usually needs a harvest sensor ($80 to $180), and if you have ice for service that can wait for a morning visit.

What to tell the dispatcher

Our line, (754) 345-4515, is answered 24/7. Technicians come out 9 AM to 7 PM every day, and a cooler or freezer losing temperature goes ahead of routine calls. After 7 PM an on-call technician handles emergencies. Without a service agreement that visit has a $150 emergency dispatch fee, waived when you approve the repair.

The call goes faster with a few things in hand. Read the brand, model and serial number off the data plate (a phone photo is fine), say what the unit is doing and since when, and have your temperature log and a list of what you already checked. Tell the dispatcher how the tech reaches the equipment too, like a roof hatch key or a loading-dock code.

Everything we fix in a restaurant kitchen is listed on our restaurant equipment repair page, with typical prices. A walk-in or freezer emergency can also be booked through walk-in cooler repair, and a fryer through fryer repair.

After the emergency

Most emergencies we answer had an early warning: a coil nobody had cleaned since spring, a gasket with a torn corner, a fryer pilot that got relit twice that week. Ask the technician what failed and why, and write it next to the temperature log. If the same unit fails twice in one season, price a preventive maintenance plan. Our maintenance checklist for Florida heat covers what your staff can do between visits.

Need a commercial tech on site?

$89 commercial service call, free with the approved repair. Same-day dispatch across South Florida.

Call (754) 345-4515Request Service